Microchip – PIC18F4620-I/PT TQFP
DOWNLOADS:
Product Features:
- Up to 10 MIPS Performance at 3V
- C compiler optimized RISC architecture
- 8×8 Single Cycle Hardware Multiply
- Internal oscillator support-31 kHz to 8MHz with 4xPLL
- Fail-Safe Clock Monitor- allows safe shutdown if clock fails
- Watchdog Timer with separate RC oscillator
- Wide operating Voltage range; 2.0V to 5.5V
- An integrated LCD driver module, capable of driving 48 segments and 4 commons for LCD display (132 pixels)
- Run, Idle and SLEEP modes
- Idle mode currents down to 5.8uA typical
- Sleep mode currents down to 0.1uA typical
- 10-bit ADC, 12 channels, 100K samples per second
- Programmable Low Voltage Detection Module
- Programmable Brown-out-Reset Module
- Two Analog Comparators
- Master Synchronous Serial Port supports SPI™ and I2C™ master and slave mode
- EUSART module including LIN bus support
- Four Timer modules
- Up to 5 PWM outputs
- Up to 2 Capture / Compare
Related products
Microchip – PIC10F202T-I/OT SOT23-6
Alternate Products:
The PIC10F202 is a low-cost, high-performance, 8-bit, fully-static, Flash-based CMOS microcontroller. It employs a RISC architecture with only 33 single-word/ single-cycle instructions. All instructions are single cycle (1 µs) except for program branches, which take two cycles. It delivers performance in an order of magnitude higher than competitors in the same price category. The easy-to-use and easy to remember instruction set reduces development time significantly.
DOWNLOADS:
Microchip – PIC12F629-I/SN SOIC
Alternate Products: PIC16F18313
This powerful (200 nanosecond instruction execution) yet easy-to-program (only 35 single word instructions) CMOS Flash-based 8-bit microcontroller packs Microchip’s powerful PIC® MCU architecture into an 8-pin package and features 1 channel comparator and 128 bytes of EEPROM data memory. This device is easily adapted for automotive, industrial, appliances and consumer entry-level product applications that require field re-programmability.
DOWNLOADS:
Microchip – PIC12F683-I/SN SOIC
Alternate Products: PIC16F18323
The Low Pin-count (8) PIC® Flash microcontroller products offer all of the advantages of the well recognized mid-range x14 architecture with standardized features including a wide operating voltage of 2.0-5.5 volts, on-board EEPROM Data Memory, and nanoWatt Technology. Standard analog peripherals include up to 4 channels of 10-bit A/D, an analog comparator module with a single comparator, programmable on-chip voltage reference and a Standard Capture/Compare/PWM (CCP) module.
DOWNLOADS:
Microchip – PIC16F876A-I/SO SOIC
Alternate Products: PIC16F886
A newer device is available. Please consider the PIC16F886. This powerful (200 nanosecond instruction execution) yet easy-to-program (only 35 single word instructions) CMOS FLASH-based 8-bit microcontroller packs Microchip's powerful PIC® architecture into an 28-pin package and is upwards compatible with the PIC16C5X, PIC12CXXX and PIC16C7X devices. PIC16F876 features 256 bytes of EEPROM data memory, self programming, an ICD, 5 channels of 10-bit Analog-to-Digital (A/D) converter, 2 additional timers, 2 capture/compare/PWM functions, the synchronous serial port can be configured as either 3-wire Serial Peripheral Interface (SPI™) or the 2-wire Inter-Integrated Circuit (I²C™) bus and a Universal Asynchronous Receiver Transmitter (USART). All of these features make it ideal for more advanced level A/D applications in automotive, industrial, appliances and consumer applications.
DOWNLOADS: